Ok, so I have been working on this figure print application and have been using the sample program and its just not clean or smooth. I really need to talk to it straight to the DLL
I have the docs here and DLL and samples here: http://premierdistributor.com/TrueAPI_SDK1.zip
What I need is to know the correct way to call these function so I can: Init the system, store prints, load prints, and verify prints.
Also I would like to get an image of what was scanned. I know there is a way because the sample program offers a lot to show off its functionallity.
The USB figure print device is about $20 on amazon and its called the Upek TrueMe.
Please email me at joe@consultingjoe.com
Thank you.
Let me know if you have any questions.
I NEED THIS ASAP!
I have the docs here and DLL and samples here: http://premierdistributor.com/TrueAPI_SDK1.zip
What I need is to know the correct way to call these function so I can: Init the system, store prints, load prints, and verify prints.
Also I would like to get an image of what was scanned. I know there is a way because the sample program offers a lot to show off its functionallity.
The USB figure print device is about $20 on amazon and its called the Upek TrueMe.
Please email me at joe@consultingjoe.com
Thank you.
Let me know if you have any questions.
I NEED THIS ASAP!